GB IDAN Manual Del Usario página 61

3
check the recline angle. adjust the seat angle
until the red level line on the infant carrier is
level with the ground. a tightly rolled towel or
pool noodle may be placed under the infant
carrier near the vehicle seat back to adjust
the angle. see page 65.
the gB idan is allowed to touch the vehicle
seat(s) in front of it, as long the recline angle
of the gB idan is not affected.
always have the handle locked in position a
while using this child restraint in a vehicle.
4
grab the infant carrier at the Belt guides and
pull from side to side and front to back to
make sure it is installed correctly. the infant
carrier should not move more than 1 inch (2.5
cm) in any direction.
if the infant carrier is next to a vehicle door
or panel, extend the adjacent l.s.p. (linear
side-impact protection) device. see page 63.
if the infant carrier moves too much, tighten
the vehicle belts more and recheck. you
may try a different vehicle seat or installation
method, or both.
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
3
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
4
61