Amprobe ACD-45PQ Manual De Uso página 16

Set the slide-switch function-selector to the "3~Bal • 1~" Power position. Setup
power measurements as mentioned in the previous "Single-Phase Power &
3-Phase Balanced-Load Power functions" section
• To start ("
buttons at the same time. Annunciator "
accumulated time (in Hour) is displayed automatically in the secondary
mini display.
• To pause ("
stops flashing and is always on.
• To continue ("
Annunciator "
• To stop ("
same time again. Annunciator "
is then displayed on the LCD for immediate viewing. Annunciator "
turns on & flashes.
• When the low battery annunciator "
stop ("
Recording result as in above.
Note:
• During kWHr Recording session, real-time W, VAR, VA as well as kWHr
accumulated readings can be selected by pressing the SELECT button
momentarily. A flashing "
going. An always on "
• When kWHr Recording is not activated, kWHr stored result instead
of accumulated readings is displayed when selected as in above.
Annunciator "
• The meter separately stores one Single-Phase and one 3-Phase-Balanced-
Load kWHr result for later viewing. When they are being viewed, press
"3~Bal • 1~" button momentarily to toggle between them.
• When the display readings exceed 9999kWHr/999hours, exponential
readings are displayed. "2.3E4" kWHr represents 2.3 x 104 kWHr, or
23000 kWHr for example,.
") kWHr Recording, press "3~Bal • 1~" and "HOLD"
"), press "HOLD" button momentarily. Annunciator "
"), press the "HOLD" button momentarily again.
" resumes flashing.
"), press the "3~Bal • 1~" and "HOLD" buttons at the
") kWHr recording session automatically and display kWHr
" denotes that kWHr Recording is being paused.
" turns on & flashes.
" turns on & flashes. kWHr
" turns off. The kWHr Recording result
" turns on, the meter will
" denotes that kWHr Recording is still under-
10
"
"