Troubleshooting - Festo EGSP Serie Instrucciones De Utilizacion

EGSP/EGSK
11

Troubleshooting

Fault Possible cause
Squeaking noi The coupling is fitted too tight Comply with permissible coupling distances
ses, vibrations
or or
Distortions
rough operating
behaviour
Contamination/Grease supply
exhausted
Bending−critical speed excee
ded
Incorrect controller settings
Slide does not Stress too high
move
Coupling hub slipping
Foreign matter blocking slide
Slide travels be Proximity sensor does not
yond the end po switch
sition
Fig. 14
34
Remedy
(è Motor mounting kit assembly instructions)
Install EGSP/EGSK without distortion (observe
levelness of bearing surface/effective load: è
chapter 5 Mechanical installation")
Clean and grease EGSP/EGSK (è see chap
ter 8 Service and Maintenance")
Reduce positioning speed
Modify control parameters (only with servo mo
tors)
Reduce load mass
Reduce positioning speed
Check coupling fitting
Remove foreign matter
Use cover (è chapter on 10 Accessories")
Check the proximity switches, connections and
controller
Festo EGSP/EGSK 0901NH English