Spare Parts; Instructions For Use; Ignition And Adjustment Of The Cook Top Burner; Instruction For Removal Of Exhaust Gases - Lotus PC-4G Guia Para La Intalación E Instrucciones De Us

SPARE PARTS

It is possible to replace part such as cock, sparck plugs, thermocouples,burners easly.
To replace the parts proceed as follows:
• Cocks: After removing the front panel, loosen the gas connections and thermocouple fitting (1-2-3), remove the cock
and substitute it.
• Thermocouple: Remove the pot-stands, the burners and the tray, unscrew the fitting (3) at the cock and the nuts (4)
at the burner, unthread the thermocouple and substitute it.
• Spark plug: substitute the plug by removing the spring and the ignition cable.

INSTRUCTIONS FOR USE

IGNITION AND ADJUSTMENT OF THE COOK TOP BURNER

On the front panel, the respective burner is indicated above each knob from an indicator
If the flame goes out, repeat the procedure. When the knob is turned to the position , the burner flame is at the minimum
level. To turn it off, turn the knob to the 0 position.
INSTRUCTIONS FOR REMOVAL OF EXHAUST GASES
Type " A" Appliances (See Data Plate)
Combustion fumes from type " A" appliances must be removed by means of special hoods or similar devices which are
connected to efficient flues or stovepipes or directly to the outside (natural removal). Fig. 1.
If this is not possible, an extraction fan may be used if it is connected directly to the outside (mechanical removal). Fig.
2. The capacity of such a fan shall not be inferior to that established by regulations in effect.
Mechanical Removal of Exhaust Gases
The supply of gas to the appliance must be directly linked to the exhaust removal system. It must be interrupted if the capacity
of the system falls below the minimum amount established by the regulations in force.
The gas supply to the appliance must be turned on again manually.
NATURAL REMOVAL Fig.1
1) Suction hood
GB
To ignite a burner, turn the knob to the left to the mark
is pressed, simultaneously press the button marked "*", until the spark ignites the gas.
The knob should be pressed for a few seconds and then released.
GAS
IE
MECHANICAL REMOVAL Fig.2
1) Suction hood
2) Blocking device
27
.
(see the figure); while the knob
GAS