Erreka KAIROS Serie Guía Rápida De Instalación Y Programación página 10

A1 Operator 1
A2 Operator 2
5/7 M1+ Operator 1/ M2+ Operator 2
6/8 M1- Operator 1/ M2- Operator 2
● Select the number of operators using F2 (F22: one operator, F21: two operators).
● Confirm gate opening direction of A1 and A2 during system programing (first operation is close),
if does not correspond, change the cable connection M+ and M- of corresponding.
● Programme F1 for operation without encoder or limit switches (F11).
● Adjust the trapping force in accordance with the weight of the gate (parameter F3).
Maximum trapping force during system learning process: please make sure the parameter F3"
Maximum trapping force" is in F3-1 during the open/close programming.
A1 Operator 1
A2 Operator 2
G1/G4 Red cable (motor)
G2/G5 Blue cable (motor)
SW1 Main switch
● Select the number of operators using C0 (C001: one operator, C002: two operators).
● Select the directions using C1 (A1) and C2 (A2).
● Programme C7 for operation without encoder or limit switches (C700).
● Adjust the trapping force in accordance with the weight of the gate (parameter A6).
Turning direction check: after connecting the power and activating any of the key devices, the
gate makes a reset (the display shows rS): the gate closes until it reaches the stopper, assigning this
stopper with the position "gate closed" If it opens instead of closes during the reset, change turning
direction using C1 (A1) or C2 (A2).
10
NC NO
K5
CO
Electrical connections SMART-D201 (M)
K1 K2 K3
- + - + -
NC NO NC NO NC
CO CO
J4
1 2 3 4 5 6 7 8
Lit+ Lit- Lat+ M1+ M1- M2+ M2-
Lat-
Electrical connections VIVO-D203 (M)
A2
LED Azul-Memorización Radio
LED2 Pulsador o Selector de llave
+ - +
LED3 Fotocélula 1
NO NC NO
LED4 Fotocélula 2
CO CO
J5
9 10 11 12 13 14 15 16 17 18
GND
5V S1 S2 GND Lmt1 Lmt2 Lmt3 Lmt4 GND
(-)
(+)
A1 B2
A1
ANT
GND
LED2 LED4 LED3
J3
19 20 21 22 23 24 25 26
DKey SKey GND Ph1 PhVcc GND Ph2 PhVcc
VIVO-D203:
VIVO-D203M:
J7
J8