Installation Instructions - NESTOR MARTIN TQH13 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

•
Installation must conform to current building regulations.
•
The position of the appliance must respect the minimal distances in regards to combustible materials, shown
on the descriptive plate. If necessary, install a wall protector. If the ground is not tiled, (i.e. fi tted carpet,
parquet...) install a fl oor protector plate which extends out from under the appliance for at least 20cm at the
back, 20cm at the sides and 50cm at the front.
•
Make sure that the chimney is clean, free of soot or debris, and as straight as possible.
•
The chimney fl ue must be airtight and the inner walls as smooth as possible.
•
The connection between the chimney and the appliance must be as equally airtight and made of non-
combustible materials, protected, if possible, against oxidation (enamelled sheet metal, aluminium, stainless
steel...).
HEIGHT OF THE CHIMNEY
The chimney must be high enough and unconstructed to avoid backdraft. It should be protected with insulating
materials to lower the risk of sooting in the high part of the chimney fl ue, and if necessary, it should be covered
to avoid rain water from penetrating.
The chimney must be designed and built in a way to allow a suffi cient draw as to completely clear the smoke
from the inside.
As a rule:
The chimney must be at least 90cm higher that the point on the roof from which it emerges.
1.
and be at least 60cms higher than any part of the building within a radius of 3m.
2.
For the best draw, the chimney should be at least 5m long from the fl ue outlet of the appliance.
90 cm
60 cm
300 cm
INSTALLATION
91