NESTOR MARTIN TQH13 Manual De Instrucciones página 93

INSTALLING THE MOTOR AND RECEIVER
To install the motor and receiver, proceed as
follows:
Remove the control panel (2 screws)
Magnet
Strap
Pull back the strap of the magnet then wedge the
muff of the motor against the magnet.
Place the receiver in its stand and fi x the stand in
the two slots provided at the back of the appliance.
Link up the motor and the receiver with the cable,
by passing the cable from the back to the front. The
Rectagular hole
rectangular hole is provided for this.
93
8