Lenze E94ASHE Serie Instrucciones Para El Montaje página 68

8 Wiring the device modules
Communication modules
DIP switch
Pos. Description
Addressing of the bus node

O
N
d c b a
Baud
Fig.16-3
On memory modules with front-panel DIP switches you can set
the node address (labelling "1" ... "64") and
ƒ
the baud rate (labelling "a" ... "d").
ƒ

Note!
If all address switches are in the "OFF" position when the standard device is
switched on, the configurations stored under codes C00350 (node address)
and C00351 (baud rate) are valid.
Switch off the voltage supply of the standard device and then switch it on
again to activated changed settings.
Setting of the node address
The node address of the drive results from the sum of all address switches in ON position.
Setting of the baud rate
d c
OFF ON
OFF ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON ON
OFF ON
OFF ON
Displays
Pos. Colour
MS Green
DE Red
BS Green
BE Red
68
64 32 16 8 4 2 1
CAN Address
Arrangement and labelling of the DIP switches
b a Baud rate
ON OFF 10 kbps
OFF ON 20 kbps
ON ON 50 kbps
ON OFF 125 kbps
OFF ON 250 kbps
OFF OFF 500 kbps
ON OFF 800 kbps
OFF OFF 1000 kbps
ON ON Autobaud
Condition
On
On
Signalling according
to DR303-3

Description
Communication module is supplied with voltage.
Communication module is not accepted by the standard device
(see notes given in the documentation for the standard device).
CANopen state ("Z")
CANopen error ("F")
9400CAN003
EDK94ASH24 DE/EN/FR/ES/IT 3.1