Troubleshooting - Angelcare AC017 El Manual Del Propietario

4.3 - TO ADJUST THE SENSOR PAD SENSITIVITY LEVEL:
To ensure adequate monitoring of your child's movements, you can adjust the sensitivity of the Sensor Pad. Set a high
sensitivity for a newborn and a lower sensitivity as the child grows and gains weight. A thicker mattress will also need a
higher sensitivity.
Slide the Nursery Unit sensitivity level button to select between low, medium or high level.
For optimal results begin with the sensitivity
level on the button, adjusting the
sensitivity by increasing as required.
IMPORTANT
• The Sensor Pad is not designed for use with adults, children or infants older than 24 months.
• Once you are finished using the Sensor Pad, please remove it from the baby's and store it away.
4.4 - BATTERIES
NURSERY UNIT LOW BATTERY INDICATOR:
The low battery yellow light indicator will flash and an alarm
will sound every 20 seconds when the batteries on the Nursery
Unit need to be replaced.
SENSOR PAD LOW BATTERY INDICATOR:
The Sensor Pad yellow light Indicator will flash and an alarm will
sound every 20 seconds when the battery on the Sensor Pad
needs to be replaced.

TROUBLESHOOTING

FALSE ALARMS
Turn OFF the Nursery Unit.
•
• Make sure there is no bedding between the mattress and the Sensor Pad.
• If the crib has a spring or slat base, place a hardboard between the crib base and the Sensor Pad measuring at least 13'' x 13''
(33 x 33 cm) and 1/4'' (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the setup requirements. Sensitivity may need to be adjusted
(refer to Step 4.3).
Pair Sensor Pad and Nursery Unit by pressing and holding the Nursery Unit Pairing button for 2 seconds until the light blue flashes
•
and you hear a sound.
Power ON/OFF Light Indicator
Low Battery Light Indicator
Flashing green
Flashing yellow
Sensor Pad Light Indicator
Flashing red
Flashing white
Flashing yellow
Monitor is activated
Nursery Unit batteries are low
No movement is detected or
Sensor Pad lost connectivity
Monitor is paused
Sensor Pad battery is low
E
N
7