Suggested Settings - Craftsman 196.205680 Manual Del Usuario

Po
o_
JCRRFTSMAN°I
SUGGESTED SETTINGS FOR WELDER
These are recommendations only - variations in input power, welding positions, and
wire will affect the weld characteristics. Use the voltage setting and wire speed
indicated as a starting point - then adjust for variables such as stick out, travel
speed, weld angle, cleanliness of metal, etc.
Proper wire
direction
from spool
_-_ To Drive Motor
After installing new wire spool, make sure
welding wire is inserted into torch hose liner
and wire tension knob is correctly adjusted
before pulling welding torch trigger,
WELDING WIRE
.O3O in (0.8 mm) MIN/2 MINI4 MIN/5 MAX/2 MAX/4 MAX/6
Flux-Core Wire
I 'L0] II L'TH =1_'1 _111 d
:[eA','Jl:it-1_:_ _
Read all instructions and warnings SUpplied with this welder before attempting
to use or service it. Also read all warnings and cautions on the welder.
If you need assistance, call Customer Service at 1-800-227-9603.