Unpacking The Welder; Packing List; Installing The Handle; Assemble The Face Shield - Craftsman 196.205680 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Thefollowing procedures describe the process
requiredto assemble, i nstall,maintain, and pre-
pareto weldwithyournewwirefeedac welder.
UNPACKING THE WELDER
1. Removeany cartonsor bagscontaining
parts/accessories. ( Mostparts are
shippedinside the welderdoor.)
2. Openthecartons or bagspacked withyour
welder a ndinspect t heircontents f ordamage.
3. Layoutthe partsand comparethem to
the the packinglist in Table1 to
familiarizeyourselfwith the parts and
what they are called.This will help you
when readingthe manual.
PACKING
LIST
Table 1 contains
a list of the items you will
find packed
in the carton.
Table
1. Packing
List
ITEM
QTY.
Welder
1
Face Shield
1
Face Shield Handle
1
Handle
Screws
2
Shaded
Lens
1
Welder
Handle
1
Wire Brush/Hammer
1
Parts Bag
1
Contact
Tip 0.030
5
Contact
Tip 0.040
5
Nozzle
2
Wire .030 Fluxcore
(1/2lb.)
Manual,
Instruction
1
INSTALLING
THE
HANDLE
1.
Insert the tabs of the welder handle into
the slots provided
on the top of the welder.
2. Insert a large flat head screw
(included
in
the accessories
bag) into each hole on
the top of the welder
handle.
3.
With a flat tip screwdriver,
securely
tighten
both screws.
(see Figure
2)
I
1
!
!
Figure
2. Handle
Installation
ASSEMBLE
THE
FACE
SHIELD
1.
Remove
the lens retaining
pegs and
shield handle
nut from the arm of the
shield handle.
(DO NOT DISCARD!)
2.
Place the shaded lens into the space
provided on the inside of the face shield.
3.
Screw the lens retaining
nuts into the
holes to either side of the lens until they
are tight against
lens.
4.
Insert threaded
peg on shield
handle
into
hole on face shield.
Press firmly
until
threaded
peg and smaller
peg below it
are locked into place.
5.
From inside of shield,
screw the shield
handle nut tightly onto peg threads.
See Figure
3 for face shield
assembly.
Figure
3. Face Shield Assembly
POWER
SOURCE
CONNECTION
High voltage
danger
from power
source!
Consult
a qualified electrician
for proper
installation
of receptacle
at the power source.
This welder
must be grounded
while in
use to protect the operator
from electrical
shock. If you are not sure if your outlet is
properly
grounded,
have it checked
by a
qualified
electrician.
Do not cut off the
grounding
prong or alter the plug in any
way and do not use any adapters
between
the welder's
power cord and the
power source receptacle.
Make sure the POWER
switch is OFF then
connect your welder's power cord to a properly
grounded
120 Vac, 60 Hz, single phase, 15
amp power source. Do not operate this welder
if the source voltage is less than 105 Vac or
greater than 132 Vac. Contact a qualified elec-
trician if this problem exists. Improper perform-
ance and/or damage
to the welder will result if
operated
on inadequate
or excessive
power.
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido