Brake Pad Wear; Front Brake - Honda XL200 Manual Del Propietário

Owner´s Manual
Installation notes
• Reverse the removal procedure.
• Make sure that the lug (8) on the swingarm is
located in the slot (9) in the brake panel (10).
• Tighten and torque the following nut:
Axle nut torque:
88 N·m (9.0 kgf·m, 65 lbf·ft)
• Adjust the brake (page 20) and drive chain (page 53).
• Apply the brake several times and check for free
wheel rotation after the brake pedal is released.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
(8)
(10)
(8) Lug
(9) Slot
(10) Brake panel
(9)

Brake Pad Wear

(Refer to the Safety Precautions on page 41.
Brake pad wear depends upon the severity of usage,
the type of riding, and road conditions. (Generally, the
pads will wear faster on wet and dirty roads.)
Inspect the pads at each regular maintenance interval
(page 43).

Front Brake

Check the cutout (1) in each pad.
If either pad is worn to the cutout, replace both pads
as a set. See your Honda dealer for this service.
FRONT BRAKE
(1)
59
)
(1) Cutouts