GE Appliances TFX26ZPDAA Manual De Instrucciones página 17

Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recomnmnd installing a water fiher
if your water
supply has sand or particles that couM clog the
screen of tile refrigerator's water valve. Install it in
tile water line near tile refrigerator.
_] Remove file plasti( flexible (ap fiom tile water
valve (refiigerator (onne(fion).
[_ Place tile compression nut and fen_ule (sleeve)
onto tile end _ifthe robing as sho_l.
[_] Insert tile end of tile copper robing into tile
water valve refiigerator connection as far as
possible. While hoMing the nlbing, tighten the
fitting.
[_] Fasten tile copper robing into tile clarnp
provided to hold it inposidon. You may
need to pt T open the clamp,
Oneof the illustrationsbelow will look like the connection
on yourrefrigerator
1/4" Copper > TubingClamp
Tubing_ 1/4"
Compression
Nut
Remove screws {sleeve)
andfold back
access cover. Refrigerator
Connection
TubingClamp/_-., 1/4"Compression Nut
Ferrule (sleeve)
Refrigerator
Connection
Turn the Water On at the Shutoff Valve
_] Tighten any (onne(tions that leak.
_ Replace tile access covei and sciews (on soiile
Inodels).
Plug In the Refrigerator
Arrange tile coil of copper robing so that it does not
vibrate against tile back of tile refligerator or against
tile wall.
Push tile refiigerator back to tile wall.
Start the Icemaker
Set tile icemaker teeler mm to tile ON (d,)x_ll)
posidon. The icemaker will not begin to operate
until it reaches its operating temperature of 15 °F
(O °() or below. It will then begin operation
automatically if the icemaker feeler mm is in the
ON (do_ll) position.
NOTE: The icemaker may double-cycle when it
first starts, caus&g some water spillage from
the icemaker into the ice bucket. This is normal
and should not happen again.
17