About storage drawer removal
Not all features are on all models.
Drawer Removal
Drawer
Guides
When replacing flTedrawers, make
sure you slide them through flTe
drawer guides on the left side.
Drawers can easily be relil{)ved by dhing up
slightly and pulling past stop location.
Onsomemodelsyoumayneed to removethe
doorbins from the fresh food doorbefore
removingthe drawers.
If tile door prevents you fiom raking (rot
the drawers, the refigerator
will need to
be rolled tblwmd until the door opens
enough to slide the (hawers out. In some
cases when you roll the refigerator
(mt you
will need to m()ve the refigerator
to the left
asyou roll it out.
About the automaticicemaker.
A newly-installed
refrigerator may take 8 to 12 hours to begin making ice.
Feelerarm
n the STOP
icemaKe
IUDJ DOSl[IOn
.
/
@
Storage Bin
Feeler a rm
n the ON
WR_ pUSl[lOg
'-C
Automatic lcemaker fen some models)
......................
Tile icemaker will produce eight cubes per
(ycle-approximately
120 cubes in a 24-hour
period, depending
on tieezer c()mparm_ent
temperature,
room temperature,
number
of door openings and odmr use conditions.
If the refligerator
is operated befi)re the
water connection
is made to tile icemaker,
keep die ti_eler arm in tile STOP(up)
position.
&,\qmnthe refligeralor
has been connected
to the water supply, moxe tile feeler arm to
the ON (down) position.
Tile icemaker will fill _dd_ water when it co()ls
to tieezing. A newly-installed retiigerator may
take 8 to 12 hours to begin making ice (ubes.
Throw away tlle first lew batches of ice to
allow dm water line to (lear.
Raise flTeaccess door to reach the
icemaker bin.
Be sure nodling interferes with tile swing of
tile feeler arm.
It is natural
tbr several cubes to be joined
togedmr.
If ice is not used fiequemly, old ice cubes
,,,.'illbet ome (lou( b, and taste stale.
Icemaker Accessory Kit
lfy_)ur refrigerator (rid not come already
equipped with an mltomafic icemaker,
an icemaker accesso U kit is available at
exua cost.
Check tile back of tile refligerator
f)r
the specifc
icemaker
kit needed
f)r
your model.