Erreka VULCAN Guía Rápida De Instalación Y Programación página 12

P1 P2 P3 P4 P5 P6 P15 P14 P16
ST1 FT1 ST2 FT2 FCA1 FCC1

The VULCAN S operator has a safety device (cable connectors 5 and 6), making it necessary to use the
VIVO-M101(M) switchboard. In order for this device to work properly, first connect cable connectors 5 and
6 of the operator to the FCA cable connectors of the VIVO-M101(M) switchboard and place DIP12 in ON.

The VIVO-M101(M) or VIVO-M201(M) switchboard can be used for the VULCAN operator without internal
safety device.

The opening and closing pressures must be adjusted to fulfil standard EN12453:2000.

Clockwork turning increases the pressure for both screws. Anti-clockwork turning reduces the pressure.
O
Do not tighten the regulation screws (2) and (3) to the maximum, as this will result in damage.
CLOSING PRESSURE: yellow colour cap, screw (2).
The "Closing Pressure" is, more exactly, the pressure
during the extension of the spindle. In inward opening
facilities, it corresponds to the closing operation. In
outward opening facilities, it corresponds to the opening
operation.
12
VULCAN
G1 G2 G3
P7 P8 P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
24Vac Lamp. MOTOR1 (G2-G1-COM)
STOP LOCK
Light
VIVO- M101:
230Vac/ 50Hz
VIVO- M101M:
125Vac/ 60Hz
Adjusting the opening and closing pressures
Electrical connections
VIVO-M101(M)
P1 P2 P3
N L
POWER
ST1 FT1
N L
P140W
OPENING PRESSURE: white colour cap, screw (3).
The "Opening Pressure" is, more exactly, the pressure
during the retraction of the spindle. In inward opening
facilities, it corresponds to the opening operation. In
outward opening facilities, it corresponds to the closing
operation.
VULCAN S
P4 P5 P6 P15 P14 P16 P7 P8 P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
24Vac Lamp.
ST2 FT2 FCA1 FCC1 STOP LOCK
Light
G1 G2 G3
N L
POWER
MOTOR1 (G2-G1-COM)
N L
VIVO- M101:
230Vac/ 50Hz
VIVO- M101M:
125Vac/ 60Hz
P140W1