Switching Maximum Or Minimum Value; Switching Functions - koban KP 2102 Manual Del Usuario

manual mode.
Press the "Hz/%"button again,
meter will be back to the condition
of the voltage or current measuring.
Note:
During working at maximum or
minimum value measuring function,
the meter can't be changed into
frequency or duty cycle measuring
mode.
Switching Maximum Or
Minimum Value
press the maxim/minimum button to
enter into the maximum mode, the
maximum will always be measured.
and press this button again, it is the
same with the minimum.
After entering into
maximum /minimum mode, there
is no more analog function and
auto power off function will also be
canceled too.
After entering into
maximum/minimum mode, the
maximum/minimum data will be
recorded automatically.
Press the max/min button for more
than 2 seconds, it will be set into the
normal mode.
Note:
www.grupotemper.com
Digital clamp meter
During measuring maximum or
minimum value, the meter will be set
to manual mode automatically.
During working at frequency or
duty measuring function, the meter
can't be changed into maximum or
minimum value measuring mode.

Switching Functions

SELECT Key is a function selection
key that acts with trigger. Press the
key can choose the needed
measurement mode: To choose DC
or AC in DC/AC status, to choose
Diode or Buzzer in Diode/Buzzer
status, to choose Ohm, Cap, Diode
or Buzzer in Ohm/Cap/Diode/ Buzzer
status.
Press the key then turn on the
power, the Auto Power-off function
will be cancelled, the signal "APO"
disappears in LCD, and enter into
Sleep Status (Power-Off). Press the
key then power on will have the Auto
Power-Off function.
Back Light And Clamp
Lighting Bulb
Press the HOLD/B.L button for
two or more seconds to switch on
the back light if the light in the
environment is too dim for taking
reading, which will last for 15
seconds.
Instructions manual |
KP 2102
35