Measuring Resistance - koban KP 2102 Manual Del Usuario

Measuring Resistance

WARNING
Beware of Electrocution.
When measuring in-circuit
resistance, make sure that the
power of the circuit under test
has been turned off and that
all capacitors have been fully
discharged.
Plug the black test lead into the
COM jack and the red test lead into
the INPUT jack.
Set the rotary selector to the
range position to make the meter
get into Ω range.
Connect test leads to the two end of
the source or load for measurement.
Take the reading on the LCD.
NOTE:
1. When the input is open, "O
L"will appear on the LCD to
indicate that the range has been
exceeded.
2. For measuring resistance above
1MΩ, t may take a few seconds
to get a steady reading. This
is normal for high resistance
reading.
www.grupotemper.com
KP 2102
Digital clamp meter
OFF
400A
600 CA T lll
MAX 400A
MS2108A
40A
V
V
Ω
SEL
Hz/DUTY
B.L
MIN /%
REL
Hz
MAX HOLD
Press 2 Sec
AUTO-POWER OFF
AC/DC CLAMP METER
COM INPUT
600V
CAT. III
MAX 1000V
750V
Instructions manual | 43