Setup Menus And Data - Navman FUEL 3100 Manual De Instalación Y Funcionamiento

3-3 Setup Menus and data

From the main display, press ENT + ESC together
to start setup mode. Press
Fuel menu
ENT
FUEL
Set fuel in tank(s) when
you add or remove fuel
(see section 5)
Twin tanks: section 3-1
dUAL
Set number of fuel tanks
Off: 1 tank
On: 2 tanks
See section 3-2
SIZE
Set capacity of fuel
tank(s)
See section 3-3
motor
Set number of engines,
1 or 2
See section 3-1
CAL .F
Calibrate fuel sensor(s)
(see section 3-4)
Twin engines:
See section 3-3
dAmP.F
Set fuel damping
see section 3-5)
ESC
12
or until desired
Press or to select a setup menu
Select port or starboard engine
Press or
screens below.
Press ENT for 2 secs to reset
to single engine installation.
A BEEP will sound when
complete.
Power port sensor only.
See section 3-2.
Press and hold ENT for
2 seconds to configure port
screen to port sensor. A BEEP
will sound when complete.
Power starboard sensor
only. See section 3-4.2.
Press ENT for 2 seconds to
configure starboard screen
to starboard sensor. A BEEP
will sound when complete.
NAVMAN
menu is desplayed then press ENT to select it.
Press ESC again to return to the main menu.
to view
sensor (see section3-6)
Set speed damping (see
Calibrate speed sensor
Calibrate speed sensor
ESC
FUEL 3100 / DIESEL 3200 Installation and Operation Manual
See also section 4-1
Speed menu
ENT
InPUt
Select speed input:
No: None
GPS: GPS/NMEA
SEn: Paddlewheel
dAmP.S
section 3-7)
CAL .L
from log (see section
3-8)
CAL .S
from boat speed
(see section 3-9)
ESC