Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
manually bury the wire. Its compact size and the 15 cm blade offset
from the outside of the wheel are good examples. The handle is also
designed to quickly and easily pivot as needed to turn tight corners.
Follow the steps below :
4
4)
Turn the machine in the desired direction by grasping the arch;
5
6
7
4.
Maintenance.
Some adjustments should be performed periodically to maintain the
machine in good working condition. Here is the maintenance
Schedule :
1
1)
Move as far as possible
into the corner (See
distance recommended by
the manufacturer);
2
2)
Loosen the clamping lever
on the handle;
3
3)
Lift
the
handle
vertical;
5)
Lower the handle until
horizontal;
6)
Place your left hand on the
arch and your other hand
on the lever, to move the
machine to free from the
corner and to able to
resume the normal working
position (press on the
traction handle to move);
7)
Once out of the corner,
move the handle to the
desired position to continue
burying the wire..
ACTION
Check the blade
attachment
Check the wire guide
attachment
Check the tire pressure
Check the oil level
Check the blade
Clean the top and bottom
of the machine
Clean underneath the
guards
Clean the blade
attachment system
Clean the inside of the
wire guide
Clean the tires
until
Lubricate the blade
transmission shaft
Inspect and adjust the
belts
Inspect and tighten bolts
and nuts
Check the engine by the
Honda manual
4.1
Belt adjustment.
The Perimeter Wire Machine 600MH
belts. These should be inspected and/or adjusted every ten (10)
hours of use. In some cases, they should be replaced. The main
reasons for replacing a worn belt are: cracking, loss of material,
unraveling, uneven wear or areas shiny due to heat or slippage.
4.1.1
Adjusting the engine belt.
Loosen the 8 bolts without removing them (Figure 1,2);
●
Using your hand, apply pressure
●
to the engine mount until the belt
is tight (Figure 3);
Tighten the 8 bolts.
●
2
4.1.2
Adjusting the blade
transmission belt.
1)
Loosen the 6 bolts (see Figure);
2)
Move the blade transmission to
achieve the desired tension;
3)
Re-tighten the 6 bolts.
BEFORE / EVERY
10
25
100
Use
Storage
hours
hours
hours
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
is equipped with three (3)
TM
3
4
EN
AFTER
Use
X
X
X
X
X
1
6
Publicidad
Tabla de contenido
