Descargar Imprimir esta página

Enduro ELITE SM1050-2P Instrucciones Para El Usuario Y Listado De Piezas página 10

Publicidad

10 - ENGLISH
Error Messages and Trouble Shooting
When an error message appears on the display the motor will stop automatically to protect the electronics
of the motor and most importantly, to protect the motor circuit board.
If an error message occurs be sure to repeat the action that caused the error message. Many times if
you reactivate the treadle and start the motor again, the error message will clear indicating this was a
False error message requiring no further action.
There are two types of error messages:
1) False error messages
2) True error messages if the error is repeated.
False errors messages are common in areas where the electricity being supplied is unstable due
to fluctuations, interference and spikes in electrical power supply to the motor. If these False error
messages happen quite often it is recommended to contact a local electrician to see if the power
supplied to the motor can be filtered. Doing so will eliminate False error messages.
True error messages do occur occasionally indicating a problem with an electrical component, the
motor circuit board and on a very rare occasion, a faulty motor.
A complete and current listing of error messages and trouble shooting can be found at www.endurosaves.com.
E0: Wire connection error
1. The wire that conects to the motor is not connected well.
• Check the wire connection to be sure it is secure.
E1: Motor Control Error
1.
Most E1 error messages occur because of unstable power being supplied to the motor.
• Release the pedal when the E1 error message occurs, then push down again to activate the motor. If the E1 error
message no longer appears this was a False error due to unstable power.
2.
If the E1 error message continues to appear:
• Replace the motor circuit board with a new motor circuit board. Once the motor circuit board is replaced the E1
error message should no longer display.
3.
If the E1 error message still appears after changing the motor circuit board, this is a very rare occurrence due to a
faulty motor.
www.endurosaves.com

Publicidad

loading

Este manual también es adecuado para:

Elite sm1050-2pf