Publicidad
Installation
Put the mounting bracket of the motor upwards to the bottom of the tabletop and fix the motor to the
tabletop with the bolts provided. Connect the treadle rod with the connecting rod joint. Install the female
plug of the cable from the switch box into the power inlet socket in the back of the motor box.
Wiring
For 220 volt single phase motor follow the diagram below:
Note: When wiring the motor to the power source, connect both the black and white wires to
achieve 220 Volts (green to ground). If you are in an area (China / Europe) that supplies 220 Volts
from a single lead, then connect the power source to the black wire. The white wire will then be the
neutral and the green wire will be the ground.
Setting Up
Turn on the power switch located on the switchbox. The display
will show "POS.d" which means "needle position down", which
means the motor is now in "ready" status, ready to work or be
set.
Ready Status
"POS.d" is the factory default "ready" status setting and
means the needle position setting is POSITION DOWN.
"POS.d" is "ready" status while default setting is not changed.
Once the needle position setting is changed to "POS.u" (which
means the needle position setting is POSITION UP), then
"POS.u" becomes the "ready" status.
www.endurosaves.com
ENGLISH - 3
default "ready" status
default "ready" status
Either "POS.d" or "POS.u" will indi-
cate "ready" status, depending on
how the needle position is set.
alternate "ready" status
Publicidad
