Publicidad
Option A - Setting Slow Starting Speed via Motor Control
a. Keep "▼" button pressed for several seconds, until LED
display indicates "SET.0".
b. Press "▲" button 1 time to indicate "SET.1", which means
"Setting up No. 1".
c. Press "▼" button and LED indicates "SOT.X" (X is 0-9).
Press "▼/▲" to adjust from 0 to 9 according to your own
application. 0 means the quickest. 9 means the slowest. The
manufacturer's default setting is 0.
d. Setting will be automatically saved 5 seconds after no buttons
are pressed. The motor returns to "ready" status.
Option B - Setting Slow Starting Speed Manually
The larger the gap between the slow start shaft and the treadle bar the faster the initial
starting speed.
1. Notice the small gap
between the slow start shaft
and the treadle bar.
4. Turn both the screw nuts to
make them move upward.
2. Unscrew the lower nut
while holding the upper one to
loosen them from each other.
5. Tighten the two nuts against
each other.
www.endurosaves.com
ENGLISH - 5
default "ready" status
Either "POS.d" or "POS.u" will indi-
cate "ready" status, depending on
how the needle position is set.
alternate "ready" status
3. Press the treadle bar down,
to force the shaft to move
downward.
6. The larger gap the faster the
initial starting speed.
Publicidad
