Publicidad
4 - ENGLISH
Motor Rotating Direction Setting
Setting up Number 2
a. Keep "▼" button pressed for several seconds, until LED
display indicates "SET.0".
b. Press "▲" button 2 times. It will now indicate "SET.2", which
means "Setting up No. 2".
c. Press "▼" button until the LED indicates "roT.E" or "roT.P".
Press "▼/▲ " to switch between E and P, to meet the desired
requirement.
"E" means the motor will run in reversed direction.
"P" means the motor will run in normal direction.
d. Setting will be automatically saved 5 seconds after no buttons
are pressed. The motor returns to "ready" status.
Slow Starting Speed
Setting up Number 1
1. The "slow period time" = 128milliseconds * X, (slow starting setting), X = 0~9 (as setting up in
the motor).
2. Example: The treadle is depressed approximately half way down producing a motor speed
of about 2,000 RPM and if the Slow Starting is set at 9, then the time from 0 to 2000RPM is
theoretically 128 milliseconds X 9 = 1152 milliseconds, plus the electrical-mechanical delay
which is about 0.8 seconds.
3. If the Slow Starting is set at 0, the "real starting time" and time from 0-2000RPM is about 0.8
seconds, which is due to the unavoidable electrical-mechanical delay.
www.endurosaves.com
default "ready" status
Either "POS.d" or "POS.u" will indi-
cate "ready" status, depending on
how the needle position is set.
alternate "ready" status
Publicidad
