Publicidad
8 - ENGLISH
Needle Position Setting For all Motors with Positioner
a. At any time when the motor is on but not running, press the
up button "▲".
If the LED indicates: "POS.u" it means the needle position
setting is POSITION UP when the sewing machine is
stopped.
If the LED indicates: "POS.d" It means the needle position
setting is POSITION DOWN when the sewing machine is
stopped. This is the default factory setting.
b. Press "▼/ ▲" to switch the setting of the needle position
between either UP or DOWN.
For Motors Without Foot Lift (Enduro
When positioner is set to the UP position and you stop sewing, the needle will stop in the UP position.
If you then heel the treadle, the motor will rotate to put the needle in the DOWN position.
When the positioner is set to the DOWN position and you stop sewing, the needle will stop at the DOWN
position. If you then heel the treadle, the motor will rotate to put the needle in the UP position.
Foot Lift 24 Volt DC Output
The foot lift shares the treadle for motor control. Pressing the pedal forward starts the motor. If you
then heel the treadle it triggers a sensor inside the motor and outputs 24 volt to operate the foot lift
solenoid (not supplied).
Note: Heeling back a second time will cause the heel back needle position to activate. See Setting up
Number 4.
There are various types of electro mechanical and electro magnetic foot lifts available which either
come with the sewing machine or can be retro fitted to the machine. Consult the dealer where you
purchased your Enduro™ 1050-2PF Motor for additional information.
SM1050-2P)
™
www.endurosaves.com
alternate "ready" status
Either "POS.d" or "POS.u" will indi-
cate "ready" status, depending on
how the needle position is set.
ready status
default "ready" status
Publicidad
