Craftsman 124.47747 Manual Del Operador página 10

THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
4. Tighten the drill press head into position
on the column by locking the hex screws on
both sides of the casting. FIG. 4.
NOTE: It is important that the chuck mounting
hole and spindle are free of any grease or rust
protection before they are installed together in
step 5. Use ordinary household grease remover
to clean these mating surfaces.
5. Slide the 1/2" chuck (FIG. 5, A) over the
pre-installed spindle (B). Open the
chuck jaws fully and tap into place using a
rubber mallet or a hammer and block of wood.
This will properly seat the chuck onto the
spindle.
NOTE: NEVER HIT THE CHUCK ASSEMBLY
WITH A METAL HAMMER. This could
damage the chuck assembly or spindle.
6. Install the three feed handles into the threaded
holes in the feed shaft's hub. FIG. 6, A.
NOTE: When using the drill press, one or two of
the feed handles may be removed if an unusually
shaped workpiece interferes with handle rotation.
Upon completion of your drilling, the removed
handle(s) must be reinstalled on the machine
immediately to avoid any future safety issues.
ASSEMBLY
B
A
A
10
FIG. 4
FIG. 5
FIG. 6