Nice Era Mat A Instrucciones Y Advertencias De Instalación Y Uso página 10

5.11 - Memorisation of a climate sensor connected via radio
To perform the procedure you must have a transmitter ("old") already memorised in "Mode 1".
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. (on the climate sensor) Keep the yellow key pressed for 10 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Give for 3 pulse to the n key, provided it has already been memorized.
03. (on the climate sensor) Keep the yellow key pressed for 2 seconds: the motor performs 3 movements to confirm the memorisation. Warning! If the motor
performs 6 movements, it means that its memory is full.
01
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.12 - Adjustment of motor sensitivity to obstacles ("Obstacle detection" function)
The motor has an "Obstacle detection" which intervenes when the movement of the rolling shutter during raising or lowering is blocked suddenly by an obstacle (an
object, a person, etc.) or by severe friction due to ice formation, expansion of the materials or other causes. In these cases, the motor immediately stops the manoeuvre
in progress and performs a brief inversion of the motion.
The following procedure makes it possible to adjust sensitivity to the obstacle, i.e. the force that the motor must exert on the obstacle to free the rolling shutter so that
function intervenes only in the presence of actual obstacles, and ignores small friction events caused, for example, by the four sliding of the slats in the tracks.
Attention! – If the set level frequently stops the rolling shutter for no good reason, it is recommended to change that level. If the trouble persists, it is recommended to
deactivate the function by setting level 4.
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the s and n keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the keys.
02. Briefly press the s key a few times, depending on the level you want to set for motor sensitivity:
1 pulse = minimum sensitivity
2 pulses = standard sensitivity (factory setting)( * )
3 pulses = maximum sensitivity
4 pulses = sensitivity deactivated
After about 10 seconds, the motor performs the number of movements indicated by the level number selected. Note - If this does not occur, cancel the procedure.
This way, the adjustment is completed without changing the factory setting.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
03
3
5
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
9 – English
02
"P1" "P1"
10
sec.
Old
02
2
THE
END
END
example
03
X 3
0,5
sec.
x 1 = sensibilità minima
x 1 = minimum sensitivity
x 2 = sensibilità standard( * )
x 2 = standard sensitivity( * )
x 3 = maximum sensitivity x 3 = sensibilità massima
0,5
sec.
x 4 = sensitivity deactivated
x 4 = sensibilità disattivata
"P1"
3
2
sec.
1 /
2 /
? 3 /
10
sec.
4 /
THE
END
END