Nice Era Mat A Instrucciones Y Advertencias De Instalación Y Uso página 6

5.6.2 - To adjust the LOWER limit switch ("1")
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the t key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Adjustment of height: Keep the t (or s) key pressed until the shutter reaches the desired "1" height. Note – to adjust the height with precision, press the s
and t several times consecutively (at each pulse theshutter moves a few millimeters.
05. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
04
Notes • When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements. • After the adjustments, the s key will command the Raising motion and the key t key will com-
mand the Lowering motion. The shutter will move within the limits constituted by the two limit switch heights.
5.7 - Manual height adjustment of upper limit switch ("0") and lower limit switch ("1")
Warnings • This procedure overwrites previously adjusted heights with the new heights using this same procedure. • Every time the motor is powered, 2 movements
are performed if at least one transmitter and the limit switch heights are not in the memory. • Memorizing the limit switches with this procedure, the two heights are con-
trolled and updated constantly by the "limit switch self-update" function (see paragraph 7.3).
Before starting the procedure, bring the rolling shutter to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the shutter to start Moving up. Then, release the key. Attention! – If the shutter starts moving in the opposite direction,
press the t (or s) key to invert the motor rotation direction. Shutter will start moving up and will be stocked automatically by the impact of the safety plugs against
the structure (the motor will memorize this height as the UPPER limit switch "0").
04. Then the shutter will start moving Down and will be stopped automatically by the intervention of the anti-intrusion springs (the motor will memorize this height as
the LOWER limit switch "1"). Note – In case of need, to promptly stop the motor, press the n key (the command also cancels the procedure).
01
5
sec.
Notes • When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements. • After programming, the s key will command the Raise motion and the t key will command
the Down motion. The shutter will move within the limits created by the mechanical blocks of the limit switches.
5 – English
02
2
05
3
"1"
5
sec.
ATTENTION! – Programming intended exclusively for the rolling shutters with the mechanical
blocks for the limit switch.
02
2
4
5
sec.
THE
END
END
4
5
sec.
"0"
03
2
5
sec.
03
5
sec.
04
"1"
THE
END
END