GYS CT 160 Manual Del Usaurio página 7

Translation of the original instructions
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery.
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply.
• This machine is fuse-protected.
Maintenance:
• If the power supply cable is damaged, it must only be replaced
by a cable specified or supplied by the manufacturer or its after-
CT 210
sales service.
• If the power supply cable is damaged, it must be replaced by the
CT 160
manufacturer, its service agent or an equally qualified person.
• Service should be performed by a qualified person.
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• If the internal fuse is blown, it must be replaced by the manufacturer,
its after-sales service or an equally qualified person.
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Réglementation :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Mise au rebut :
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
CT 160 / 210
EN
7