ExtraStove ES 15iD Manual De Instrucciones página 24

GB
8.0 Annual maintenance by the Authorized Assistance
Centre
The following operations are to be programmed annually by the Authorized Assistance
Centre and are necessary to insure that the product remains efficient and guarantee
safe operation.
• Careful cleaning of the combustion chamber;
• Cleaning and inspection of the smoke clearing ducts;
• Checking the seal of the gaskets;
• Cleaning the mechanisms and moving parts (motors and fans);
• Checking the electrical parts and the electronic components.
8.1 Operations to perform every season before the first lighting
• A general cleaning inside and outside;
• A careful cleaning of the exchange tubes;
• A careful cleaning and disincrustation of the crucible and the relative cavity;
• Clean the motors, checking the play and fastenings of the mechanisms;
• Clean the smoke channel (substitute the tube gaskets) and smoke extractor fan cavity;
• Clean silicone tube connected to the pressure switch;
• Clean, inspect and disincrust the lighting resistor cavity, replacing it if necessary;
• Clean/check the synoptic panel;
• Visually inspect the electrical cables, the connections and the electrical power cable;
• Clean the pellet container and verify the play with the screw feeder gear motor;
• Replace the door seals;
• Functional assessment, loading the screw feeder, lighting, 10 minutes of operation
and shut down.
WARNING! In case of fire inside the chimney, immediately contact the firefighters.
Model: ES 15iD
Heating input (min-max)
Nominal heat output
Reduced heat output
Nominal heat output to Water
Reduced heat output to Water
CO emissions at 13% O2 (nominal heat)
CO emissions at 13% O2 (reduced heat)
Efficiency at nominal heat output
Efficiency at reduced heat output
Flue gas temperature at nominal heat output
Flue gas temperature at raduced heat output
Draught (min-max)
Volltage
Frequency
Electrical comsumption (ignition)
Electrical comsumption (working)
Maximum operating water pressure
Weight
Maximum water temperature
Exhaust gas flow (at rated power)
Exhaust gas flow (at raduced power)
Water content
The indicative heatable surface is 400 m
Model: ESP 15iD
Heating input (min-max)
Nominal heat output
Reduced heat output
Nominal heat output to Water
Reduced heat output to Water
CO emissions at 13% O2 (nominal heat)
CO emissions at 13% O2 (reduced heat)
Efficiency at nominal heat output
Efficiency at reduced heat output
Flue gas temperature at nominal heat output
Flue gas temperature at raduced heat output
Draught (min-max)
Volltage
Frequency
Electrical comsumption (ignition)
Electrical comsumption (working)
Maximum operating water pressure
Weight
Maximum water temperature
Exhaust gas flow (at rated power)
Exhaust gas flow (at raduced power)
Water content
The indicative heatable surface is 400 m
Model: WO 155W
Heating input (min-max)
Nominal heat output
Reduced heat output
Nominal heat output to Water
Reduced heat output to Water
CO emissions at 13% O2 (nominal heat)
CO emissions at 13% O2 (reduced heat)
Efficiency at nominal heat output
Efficiency at reduced heat output
Flue gas temperature at nominal heat output
Flue gas temperature at raduced heat output
Draught (min-max)
Volltage
Frequency
Electrical comsumption (ignition)
Electrical comsumption (working)
Maximum operating water pressure
Weight
Maximum water temperature
Exhaust gas flow (at rated power)
Exhaust gas flow (at raduced power)
Water content
The indicative heatable surface is 400 m
24
4,1 kW - 14,9 kW
13,4 kW
4,0 Kw
11,2 kW
3,1 kW
0,020%
0,043%
90,00%
96,60%
173,3 °C
66,8°C
10-12 Pa
230 V
50 Hz
400 W
120 W
2,0 Bar
186 kg
75°C
9,1 g/s
3,5 g/s
10 l
3
4,1 kW - 14,9 kW
13,4 kW
4,0 Kw
11,2 kW
3,1 kW
0,020%
0,043%
90,00%
96,60%
173,3 °C
66,8°C
10-12 Pa
230 V
50 Hz
400 W
120 W
2,0 Bar
186 kg
75°C
9,1 g/s
3,5 g/s
10 l
3
4,1 kW - 14,9 kW
13,4 kW
4,0 Kw
11,2 kW
3,1 kW
0,020%
0,043%
90,00%
96,60%
173,3 °C
66,8°C
10-12 Pa
230 V
50 Hz
400 W
120 W
2,0 Bar
186 kg
75°C
9,1 g/s
3,5 g/s
10 l
3