8- Error Messages; 9- Troubleshooting - Vimar ELVOX RS10 Manual Para El Conexionado Y El Uso

RS10
8 . E rror messages
Message D escription
F02 Detected an obstacle during the opening movement
F03 Detected an obstacle during the closing movement
F04 PHOTO input contact open
F06 STPA input contact open
F09 Maximum opening or closing time elapsed
F11 PHOTO input test failed
F12 STPA input test failed
9 . T roub lesh ooting
P rob lem
Automation does not work
You cannot save the remote controls
You cannot enter travel
programming
As soon as the gate starts it stops and rever-
ses
During slowdown, the gate stops and rever-
ses
The gate stops a few centimetres after the
limit switch has tripped
30
C ause
No mains supply
Blown fuses
Control and safety inputs not working
Batteries of the remote control discharged
Remote control not compatible with the first one
saved
Reached memory saturation
Safety devices open
Low acceleration on starting
Encoder not detected
Slowdown speed too low
High inertia
EN
Solution
Check the power line switch
Replace the fuses with others of the same
value
Check the diagnosis LEDs (STOP, STPA and
PHOTO must be on)
Replace the batteries.
The first saved remote control configures the
control unit to save only rolling-code remote
controls or only dip-switch remote controls.
Delete at least one remote control or add an
external receiver (maximum capacity 128 remo-
te controls).
Check the diagnosis LEDs (STOP, STPA and
PHOTO must be on)
Increase parameter 15 and 16 (motor force and
force on obstacle) and set parameter 24 On
(break-out on starting).
Check the encoder connector is properly inser-
ted or if there is no encoder insert the jumper in
connector CN6 (the control unit is configured to
operate with or without the encoder when pro-
gramming the travel)
Increase parameter 13 and 14 (slowdown
speed on opening and closing)
Increase the value of parameter 17 (braking
power)