Replacement Parts And Accessories - Hach 3400 Serie Manual Del Usuario

Table 8 Event list for conductivity sensors (continued)
Event Description
RESET CONFIG The configuration was reset to the default options
POWER ON EVENT The power was turned on
ADC FAILURE The ADC conversion failed (hardware failure)
FLASH ERASE The external serial flash memory erase occurred
TEMPERATURE The temperature is out of range (-20 to 200 °C)
SAMPLE CAL START Start of calibration for conductivity
SAMPLE CAL END End of calibration for conductivity
ZERO CAL START Start of zero calibration
ZERO CAL END End of zero calibration

Replacement parts and accessories

Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
Consumables
Description
Conductivity reference solution, 100–1000
µS/cm
Conductivity reference solution, 1000–
2000 µS/cm
Conductivity reference solution, 2000–
150,000 µS/cm
Conductivity reference solution, 200,000–
300,000 µS/cm
2
For use with a 0.05 cell constant sensor only. Sample volume is limited to approximately 20 mL.
18 English
Quantity Item no.
1 L 25M3A2000-119
1 L 25M3A2050-119
1 L 25M3A2100-119
1 L 25M3A2200-119
Parts and accessories
Description
Fitting, compression, ½-in. PVDF (Kynar)
Fitting, compression, ¾-in. PVDF (Kynar)
Fitting, compression, ½-in. 316 stainless steel
Fitting, compression, ¾-in. 316 stainless steel
2
Flow chamber , low-volume, PVDF
2
Flow chamber , low-volume, 316 stainless steel
Gasket, EDPM, for 1½-in. sanitary sensors
Gasket, EDPM, for 2-in. sanitary sensors
Gasket, Viton, for 1½-in. sanitary sensors
Gasket, Viton, for 2-in. sanitary sensors
Sanitary clamp, 1-½-in. heavy duty
Sanitary clamp, 2-in. heavy duty
Sanitary tee, 1-½-in.
Sanitary tee, 2-in.
Item no.
1000F1236-111
1000F1236-122
4H1285
4H1135
1000G3316-101
1000A3316-102
9H1381
9H1327
9H1383
9H1384
9H1382
9H1132
9H1388
9H1310