Rules For Returning And Rapairing - Moretti LEM Aspimed 2.2 Manual De Instrucciones

COMPLYING WITH THE NEW EUROPEAN RULES, MORETTI INDICATES THE IMPORTANT POINTS TO PROTECT INSTRUMENT AND
OPERATORS HYGIENE. THESE RULES MUST BE RESPECTED IN ORDER TO GUARANTEE HYGIENE AND SAFETY TO ALL THE PEOPLE
OPERATING WITH THE INSTRUMENT TO OBTAIN QUALITY AND WELL BEING.
Every returned instrument will be hygienically checked before repairing. If MORETTI finds instrument not suitable for repairing due to
clear signs of internal or external contamination, the same will be returned to customer with specification of NOT REPAIRED
INSTRUMENT, accompanied by an explanation letter. MORETTI will decide if contamination is due to bad functioning or misuse. If
contamination is due to bad functioning, MORETTI will substitute the instrument, only if a SALE RECEIPT and STAMPED GUARANTEE
accompany the same.
MORETTI is not responsable for contaminated accessories, they will be substitute at customer's expenses.
For this reson it is COMPULSORY to carefully disinfect the external part of the instrument and accessories with a cloth soaked in
methylated spirits or hypochlorite-based solutions. Put the instrument and accessories in a bag with indication of disinfecting. We also
request to specify the kind of fault, in order to speed up repairing procedures. To this end, please read the instructions carefully in order
to avoid damaging the equipment through improper use. Always specify the fault encountered so that MORETTI can establish whether it
falls into the category of the faults covered by the guarantee.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE
2002/96/EC:
At the end of its working life, the product must not be disposed of as urban waste. It must be taken a special local
authority differeatialed waste collection or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from
inappropriate disposal and enables the constituent materials to be recovered to obtain significant saving in energy and resourses.
As a reminder of the need to dispose of separately the product is marked with a crossed-out wheeled dustbin.
•
Place the unit on a flat, horizontal surface
•
Connect one end of the short silicon tube, with antibacterial filter, to the suction connector on the lid of the jar.
•
The other tube already connected to the filter has to be connected to the "VACUUM" jar outlet, where has been fixed the red float
(security float). When the 90% of the volume of the jar is reached there is the activation of the security float (the float close the
aspiration connector on the jar) to avoid liquid penetration inside the device.
WARNING: Ensure that the FLUID SIDE or IN marker on the filter is on the side facing the collection jar lid and fitted into the "VACUUM".
A wrong connection causes immediate destruction in case of contact with sucked liquids.
Filter assembling
Suction Pump
Inlet
•
Connect the long silicone tube to the "PATIENT" jar outlet
•
Connect the other end of the long silicon tube to the probe plastic connector, then connect the suction probe to it.

RULES FOR RETURNING AND RAPAIRING

INSTRUCTION FOR USE
FLOW DIRECTION
IN
17
IN / Fluid Inside
Jar Air Tube