Lighting Instructions - COZY W255 Instrucciones De Instalación Y Funcionamiento

MODELS:
A. This appliance has a pilot which must be
WARNING:
lighted by hand. When lighting the pilot,
If you do not
follow these instructions exactly.
follow these
B. BEFORE LIGHTING smell all around the
instructions
appliance area for gas. Be sure to smell
exactly, a fire
next to the floor because some gas is
or explosion
heavier than air and will settle on the floor.
may result
causing
WHAT TO DO IF YOU SMELL GAS:
property
• DO NOT try to light any appliance.
damage,
• DO NOT touch any electric switch;
personal
injury or loss
• Immediately call your gas supplier from
of life.
1. STOP! Read the information on the safety label.
2. Set thermostat to it's lowest setting.
3. Open cabinet door.
4. Depress and turn gas control knob clockwise
to "OFF".
Gas Control Knob
PILOT ADJ
Pilot Adjustment Internal Manifold
Screw Cap Pressure Regulator
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
5. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the information on the safety
label. If you don't smell gas, go to the next step.
6. Locate the pilot. (Follow metal pilot tube from gas
control).
7. Turn gas control knob counterclockwise
to "PILOT".
1. Set the thermostat to it's lowest setting.
2. Open cabinet door.
LIGHTING INSTRUCTIONS - ( STANDING PILOT )
W255G W256G
FOR YOUR SAFETY READ BEFORE LIGHTING
DO NOT use any phone in your building.
a neighbor's phone. Follow the gas
supplier's instructions.

LIGHTING INSTRUCTIONS

Manifold
Pressure
Tap
TURNING OFF GAS TO APPLIANCE
/ W355G W356G / W505G W506G
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools. If
the knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
8. Push gas control
knob and hold in.
Immediately light
the pilot with a
match. Continue
to hold the gas
control knob in for
about one (1) minute after the pilot is lit. Release
gas control knob and it will pop back up. Pilot
should remain lit. If pilot goes out, repeat steps 4
through 8.
• If knob does not pop up when released, STOP
and immediately call your service technician or
gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
9. Turn gas control knob counterclockwise
to "ON".
10. Close the cabinet door.
11. Set thermostat to desired setting.
3. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
4. Close cabinet door.
Page 13
Back to Index
Pilot is
located
on side of
burner
1017754-A