Important Safety Instructions For Battery Packs; Storage Recommendations - Black and Decker CM1640 Manual De Instrucciones

wARNING:
• Do NoT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery pack
are specifically designed to work together.
• These chargers are not intended for any uses other than charging
designated Black & Decker rechargeable batteries. Any other uses
may result in risk of fire, electric shock or electrocution.
wARNING:
• The charger supplied with this product is intended
to be plugged in such that it is correctly orientated in a vertical or
floor mount position.
• Do not expose charger to rain or snow.
• pull by plug rather than cord when disconnecting charger. This
will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary.
Use of improper extension cord could result in risk of fire, electric
shock, or electrocution.
• Do not place any object on top of charger or place the charger on
a soft surface that might block the ventilation slots and result in
excessive internal heat. place the charger in a position away from
any heat source. The charger is ventilated through slots in the top
and the bottom of the housing.
• Do not mount charger on wall or permanently affix charger to any
surface. The charger is intended to use on a flat, stable surface (i.e.,
table top, bench top).
• Do not operate charger with damaged cord or plug — have them
replaced immediately.
• Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Take it to an
authorized service center.
• Do not disassemble charger; take it to an authorized service center
when service or repair is required. Incorrect reassembly may result in
a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any
cleaning. This will reduce the risk of electric shock. Removing the
battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical
power (120 Volts). Do not attempt to use it on any other voltage.

IMpoRTANT sAfETy INsTRuCTIoNs foR bATTERy pACks

wARNING:
For safe operation, read this manual and manuals
originally supplied with tool before using the charger.
The battery pack is not fully charged out of the carton. Before using the
battery pack and charger, read the safety instructions below. Then fol-
low charging procedures outlined.
READ ALL INsTRuCTIoNs
• Do not incinerate the battery pack even if it is severely damaged
or is completely worn out. The battery pack can explode in a fire.
Toxic fumes and materials are created when battery packs are burned.
• Do not charge or use battery in explosive atmospheres, such as
in the presence of flammable liquids, gases or dust. Inserting or
removing the battery from the charger may ignite the dust or fumes.
• If battery contents come into contact with the skin, immediately
wash area with mild soap and water. If battery liquid gets into the eye,
rinse water over the open eye for 15 minutes or until irritation ceases. If
medical attention is needed, the battery electrolyte for Li-ion batteries is
composed of a mixture of liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory irritation. Provide
fresh air. If symptoms persist, seek medical attention.
wARNING:
Burn hazard. Battery liquid may be flammable if
exposed to spark or flame.
• Charge the battery packs only in black & Decker chargers.
• Do NoT splash or immerse in water or other liquids. This may
cause premature cell failure.
• Do not store or use the tool and battery pack in locations where the
temperature may reach or exceed 105°F (40˚C) (such as outside
sheds or metal buildings in summer).
wARNING:
Never attempt to open the battery pack for any reason. If
battery pack case is cracked or damaged, do not insert into charger. Do not
crush, drop or damage battery pack. Do not use a battery pack or charger
that has received a sharp blow, been dropped, run over or damaged in any
way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged
battery packs should be returned to service center for recycling.
wARNING:
fire hazard. Do not store or carry battery so that metal
objects can contact exposed battery terminals. For example, do not place
battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose
nails, screws, keys, etc. Transporting batteries can possibly cause fires if the
battery terminals inadvertently come in contact with conductive materials
such as keys, coins, hand tools and the like. The US Department of
Transportation Hazardous Material Regulations (HMR) actually prohibit
transporting batteries in commerce or on airplanes (i.e., packed in suitcases and
carry-on luggage) UNLESS they are properly protected from short circuits. So
when transporting individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them and cause a
short circuit. NOTE: Batteries should not be put in checked baggage.

sToRAGE RECoMMENDATIoNs

1. The best storage place is one that is cool and dry away from direct
sunlight and excess heat or cold.
2. Long-term storage will not harm the battery pack or the charger as
long as the battery is not depleted..
ChARGING pRoCEDuRE
Black and Decker chargers are designed to charge Black and Decker battery
packs: LCS36 (2 hrs), LCS436 (6 hrs).
1. Plug the charger into an appropriate outlet before inserting the bat-
tery pack.
2. Insert the battery pack into the charger.
3. The green LED will flash indicating that the battery is being
charged.
4. The completion of charge is indicated by the green LED
remaining on continuously. The pack is fully charged and may be
used at this time or left on the charger.
Recharge discharged batteries as soon as possible after use or bat-
tery life may be greatly diminished.
ChARGER DIAGNosTICs
This charger is designed to detect certain problems that can arise with
the battery packs or the power source. Problems are indicated by one
LED flashing in different patterns.
bAD bATTERy
The charger can detect a weak or damaged battery. The red
LED flashes in the pattern indicated on the label. If you see this
bad battery blink pattern, do not continue to charge the battery. Return
it to a service center or a collection site for recycling.
hoT/CoLD pACk DELAy
When the charger detects a battery that is excessively hot or
excessively cold, it automatically starts a Hot/Cold Pack Delay,
suspending charging until the battery has normalized. After this happens,
the charger automatically switches to the Pack Charging mode. This
feature ensures maximum battery life. The red LED flashes in the pattern
indicated on the label when the hot / cold pack delay is detected.
LEAVING ThE bATTERy IN ThE ChARGER
The charger and battery pack can be left connected with the green LED glow-
ing indefinitely. The charger will keep the battery pack fresh and fully charged.
IMpoRTANT ChARGING NoTEs
1. Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 60°F and 80°F
(16°- 27°C). DO NOT charge the battery pack in an air temperature
below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important
and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a problem.
To facilitate the cooling of the battery pack after use, avoid placing
the charger or battery pack in a warm environment such as in a metal
shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding
air temperature is approximately 60°F - 80°F (16° - 27°C).
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce suf-
ficient power on jobs which were easily done previously. DO NOT
CONTINUE to use under these conditions. Follow the charging proce-
dure. You may also charge a partially used pack whenever you desire
with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to,
steel wool, aluminum foil, or any buildup of metallic particles should be
kept away from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity. Unplug char-
ger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
wARNING:
shock hazard. Do not
allow any liquid to get inside charger.
Never attempt to open the battery pack
for any reason. If the plastic housing of
the battery pack breaks or cracks, return
to a service center for recycling.
sTATE of ChARGE INDICAToR
(fIGuRE b)
The battery is equipped with a state of
charge indicator. This can be used to
display the current level of charge in the
battery while in the mower and during
4
b
b1
b2