Remote Control Operation - Hiyasu HSM-9UIHN Manual Del Usuario

Remote control operation

Note: Make sure that there is nothing between the receiver and the remote control; do not
drop the remote control; do not wet the remote control with any liquid or expose it directly
to sunlight, or place it near any heat source.
Transmitter signal
Remote control
ON/OFF
ON/OFF Key
ON / OFF: When the unit is switched on and
off, the night-time and timer functions will be
cancelled, but the pre-selected time remains
active.
MODE
MODE Key
FUNCTION: Key for selecting the sequence
mode between: Auto, Cool, Dry, Fan, Heat. The
default mode is Auto (the temperature does not
appear). With the Heat mode, the initial value
is 28 ºC. In the other modes, the initial value is
25 ºC.
Remote control name and functions
SLEEP
NIGHT-TIME OPERATION: key for
adjusting the night-time temperature. When
the unit lights up, by default, the night-time
function is switched off. When the unit is
disconnected, the night-time function is
cancelled. When the night-time function is
selected, SLEEP will appear on the screen.
This way, the timer can be adjusted. In Fan
or Auto mode this function cannot be used.
FAN
FAN: Key for selecting the fan speed.
The default mode is Auto
CLOCK
CLOCK: Key for adjusting the clock time.
The signal
for 5 seconds, the values can be adjusted by
pressing "+" or "-". With the signal flashing, if
the Clock is pressed again, the signal
will stop flashing to indicate that the clock has
been adjusted satisfactorily. When the control
is activated, by default the programmed time
is 12.00 and the symbol
screen. If this symbol does not appear, the
data will be the TIMER value.
- 6 -
SLEEP Key
FAN key
CLOCK Key
will flash on the screen and,
will appear on