Hiyasu HS-9UIEE Manual De Usuario página 26


Operation of wireless remote control
Note: Besure that there are no obstructions between receiver and remote controller;
Don't drop or throw the remote control; Don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Remote control
ON/OFF
ON/OFF button
●
Press this button, the unit will be turned on,
press it once more, the unit will be turned off.
When turning on or turning off the unit, the
Timer, Sleep function will be canceled, but the
presetting time is still remained.
MODE
MODE button
●
Press this button, Auto, Cool,Dry, Fan,
Heat mode can be selected circularly. Auto
mode is default while power on. Under
Auto mode,the temperature will not be
displayed; Under Heat mode, the initial
value is 28°C (82°F); Under other modes,
the initial value is 25°C (77°F) .
AUTO
COOL
HEAT
(Only for cooling and heating unit.
As for cooling only unit, it won't
have any action when it receives
the signal of heating operation.)
Name and function of wireless remote control
Signal transmitter
DRY
FAN
SLEEP
SLEEP button
●
Press this button, Sleep On and Sleep Off
can be selected. After powered on, Sleep
Off is defaulted. After the unit is turned
off, the Sleep function is canceled. After
Sleep function set up, the signal of Sleep
will display. In this mode, the time of timer
can be adjusted. Under Fan and Auto
modes, this function is not available.
FAN
FAN button
●
Press this button, Auto, Low, Middle, High
speed can be circularly selected. After
powered on, Auto fan speed is default.
Under DRY mode, Low fan speed only
can be set up.
Low fan
CLOCK
CLOCK button
●
Press this button, the clock can be set up,
signal
the value can be adjusted by pressing
+ or - button, if continuously press this
button for 2 seconds above, in every
0.5 seconds, the value on ten place of
Minute will be increased 1. During blinking,
repress the Clock button, signal
constantly displayed and it denotes the
setting succeeded. After powered on,
12:00 is defaulted to display and signal
time value is Clock value, otherwise is Timer
value.
– 23 –
AUTO
Middle fan
High fan
blink and display.Within 5 seconds,
will be displayed. If there is signal
be displayed that denotes the current
will be