Installing The Brackets - Craftsman 139.53918D Manual Del Propietário

INSTALLING THE BRACKETS
Be sure power to the opener is disconnected.Installand align
the brackets so the sensors will face each other across the garage
door, with the beam no higher than 6" (15 cm) above the floor.
They may be installed in one of three ways, as follows.
Garage doortrack installation (preferred):
• Slip the curved arms over the rounded edge of each door track,
with the curved arms facing the door. Snap into place against
the side of the track. It should lie flush, with the lip hugging the
back edge of the track, as shown in Figure 1.
If your door track will not support the bracket securely, wall
installation is recommended.
Waft installation (Figures2 and 3):
• Placethe bracket against the wall with curved arms facing the
door. Be sure there is enough clearancefor the sensor beam to
be unobstructed.
• If additional depth is needed,an extension bracket
(see Accessories) or wood blocks can be used.
• Use bracket mounting holes as a template to locate and drill
(2) 3/16" diameter pilot holes on the wall at eachside of the
door, no higher than 6" (15 cm) above the floor.
• Attach brackets to wall with lag screws (not provided).
• If using extension brackets or wood blocks, adjust right and
left assemblies to the same distance out from the mounting
surface. Make sure all door hardware obstructions are cleared.
Floor installation (Figure 4):
• Use wood blocks or extension brackets (see Accessories) to
elevate sensor brackets so the lenses will be no higher than
6" (15 cm) abovethe floor.
• Carefully measure and place right and left assemblies at the
same distance out from the wall. Be sure all door hardware
obstructions are cleared.
• Fastento the floor with concrete anchors as shown.
DOORTRACK MOUNT (RIGHT SIDE)
1
,oure oo r Ik
]Track
1I: L,p
_i __ Indicator
Safety ::: -
_--_ . Reversing
_..,.%('_" Sensor
"_ Bracket
Figure2
WALL MOUNT (RIGHT SIDE)
Fasten Wood Block to Wall with
Screws (not provided)
Indicator
Light Safety
Reversing
Sensor
Bracket
Lag Screws
_ (not provided)
Lens ......
WALL MOUNT (RIGHT SIDE)
Figure3 .........
_tj i : Extension Bracket
(SeeAccessories)
I.., (Provided with
_1 Extension Bracket)
(Provided with I_?,- __ _/._ _ Reversing
Extension Bracket)_"'_ _. Sensor
_ I " _racKe[
Lens Indicator
Light
HARDWARESHOWN ACTUALSIZE
Carriage Bolt Wing Nut
1/4"-20xl/2" 1/4"-20
Staples
Figure4
J
FLOORMOUNT (RIGHT SIDE)
-- ttach with
Concrete Anchors
i (not provided)
Indicator
Light
Reversing
Sensor
Bracket
21