Smart Controlpanel®Messages - Craftsman 139.53918D Manual Del Propietário

Smart ControlPanel®Messages
The following messages are contained within the Smart Control
Panel ® and may appear during the operations of the unit:
SAFETYSENSORSCHECK
ALIGNMENT,BLOCKAGE
OR IVIISWIRING SEE
OWNER'SMANUAL
SAFETYSENSORS
MALFUNCTION CHECK
IVIISWIRING SEE
OWNER'SMANUAL
LEARNREMOTE
CONTROLPRESS
LEARNBUTTON
TO CONFIRM
LEARNMODE PRESS
REMOTECONTROL
BUTTONTO PROGRAM
REMOTE
LOCKMODE REMOTE
CONTROLLOCKED OUT
PRESSLOCKBUTTON TO
ENABLE REMOTE
ENGLISH,FRAN_AIS
AND ESPANOL
MOTIONSENSINGON
MOTIONSENSINGOFF
•4) Meaning: Thismessage will appear if the Safety ReversingSensorsare out of alignment, if they
are blockedor if the wiring is disconnected.To clear messagefrom doorcontroldo the following:
• Checkto see that area is clear between the safety reversing sensors.
• Checkto see that the safety reversing sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is firmly secured to wall and does not move.
• Checkto see that the safety reversing sensors' wires are connected to the motor unit.
• If message has not cleared after the above checks, refer to message#2.
•"0 Meaning: Thismessage will appear if the safety reversingsensorsare miswired.
Toclear the message, do the following:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct wiring polarity
(black/white wires reversed), replace/attachas needed.
• Disconnect all wires from back of motor unit.
• Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 ft. (30-60 cm)
from back of each sensor.
• Reattach sending eye to motor unit using shortened wires. If sending eye indicator light glows
steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors. If the sensor indicator
lights do not light, replacethe safety reversing sensors.
•"0 Meaning: Thismessage will appear when the *LEARN' b uttonhas been pressed on the door
control Pressingthe *LEARN' b uttonagain will allow the user to programan additional remote
controlto the opener.
•"0 Meaning: Thismessage will appear when the *LEARN' b uttonhas been presseda second time on
the doorcontrol or anytime on the opener. The opener is ready to program another remote
controlby simplypressing the remote controlbutton. Oncethe opener has *LEARNED' the remote
control, the work/ight will blink one time.
•"0 Meaning: Thismessage will appear when the *LOCK'buttonhas been pressed and held for more
than one second. Thisfeature will disable the opener from receiving remote controlsignals. To
exit *LOCK' m ode, press and hold the buttonfor more than one second.
•"0 Meaning: Thismessage will appear when the *LANGUAGE' buttonhas been pressed. Pressing
the button will toggle to the next language.
•"• Meaning: Thismessage will appear when the Motion Sensing buttonis pressed. The motion
detectorwill toggle on or off with each press of the button.
36