Cattini Oleopneumatica YAK Manual Uso Y Mantenimiento página 5

EN
COMMISSIONING
REMOVING THE PACKAGING
- Remove the jack from its packaging using appropriate lifting equipment attached to the eyebolts only.
- Extract the beam from the packaging using lifting straps rated to a minimum of 300kg to ensure complete safety.
ASSEMBLY
1. Measure the width of the pit the jack is to be placed in.
2. Adjust the beam's 4 support rollers on the basis of this measurement, using the screws
3. Position the beam inside the pit.
4. Check that the beam is free to move the entire length of the pit; if necessary, correct the position of the rollers and fully
tighten the screws POS. 8 A00434 POS. 8 A00434
5. Remove the anti-roll blades
6. Insert the jack body inside the beam; take great care when performing this operation, as space is limited.
7. Install the anti-roll blades
8. Open the tank cock POS. 19 A00382 POS. 19 A00382
CONNECTION TO THE COMPRESSED AIR SYSTEM
- Compressed air enters the jack circuit through the quick coupling on the control panel of the jack; a connecting hose with
a quick coupling compatible with that of the jack is therefore required. Check that the air supply hose has a usable internal
diameter of at least 6 mm, and is not kinked or blocked anywhere.
Working air pressure: 8 - 10 BAR
- Never allow hydraulic fluid, petroleum jelly, brake fluid, petroleum or other liquids to enter the compressed air circuit.
-Install a drier-lubricator filter unit in the compressed air system.
- If you need to lubricate the compressed air circuit, use only:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100;
SHELL TELLUS 100; BP ENERGOL HP 100
to observe the indications above, and the warranty shall also be forfeit if they are not respected!
.
POS. 11 A00333 POS. 11 A00333 by unscrewing the screws
POS. 11 A00333 POS. 11 A00333 by screwing down the screws
The manufacturer shall not be liable for any damage due to failure
POS. 8 A00434 POS. 8 A00434
POS. 12 A00333 POS. 12 A00333 .
POS. 12 A00333 POS. 12 A00333 .
5