Wiring Diagrams - Eaton Portfolio LDRT2 Manual De Usuario

Installation Instructions – LDRT2 LED Retrofit www.eaton.com
Remove
Screw
Figure 10
Figure 11

Wiring Diagrams

1. For D010/D010TR
GREY GREY
0-10V
DIMMING
PURPLE PURPLE
FIELD INSTALL
BLACK LINE BLACK
WHITE LINE WHITE
GREEN GREEN
GROUND
Dimming
The Portfolio LD2B*D010 Series can be dimmed with many standard 0-10V DC dimming controls. To be assured of the latest
information regarding luminaire and dimmer compatibility, please reference the Portfolio LED website: www.portfolio-lighting.
com.
4
Remove Nuts
DRIVER
RED RED
RED
BLUE
BLACK
BLUE
Installation Instructions – LDRT2 LED Retrofit www.eaton.com
Driver Replacement
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture.
• The driver should be replaced by a qualified electrician.
1. Bring drives through the ceiling opening.
2. Remove screw from raceway (see figure 10).
3. Lift off top half of raceway (snaps at the bottom).
4. Disconnect the wiring so the driver can be removed.
5. Remove two nuts from the lower raceway
(see figure 11).
6. Discard old driver.
7 . Replace new driver. Tighten nuts to lower raceway.
Make all electrical connections (refer to appropriate
wiring diagram). Replace top half of the raceway and
drive screw to secure.
LED
CAUTION