Wiring Diagrams - Eaton Cooper Lighting PORTFOLIO LDSQ4 Instrucciones De Instalación

Installation Instructions – LDSQ4/LDSQ6 Commercial Recessed LED Rough-In
2. Remove junction box cover (Figure 11.).
3. Remove appropriate round pryout and connect conduit
to junction box with proper connector (not included).
4. Connect supply lead wires to junction box lead wires
(line, neutral and ground) in the fixture using properly
sized wire nuts. Be careful not to leave any bare
conductors outside of the wire nut connectors.
5. Connect white to white, black to black, and green
(from electrical service) on the supply side to the bare
copper wire in the junction box. Place all excess wiring
and connections into the junction box and replace the
cover. Place all connections and excess wiring into the
junction box and replace cover.
Driver Replacement
CAUTION
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture.
• The driver should be replaced by a qualified electrician.
• The driver may be replaced either from below or above the
ceiling.
1. Remove trim assembly from the housing (Figure 12.).
2. Remove the driver and junction box cover assembly.
3. Disconnect the wiring to the driver by undoing the wire
nuts.
4. Discard the old driver and junction box cover assembly.
5. Connect the new driver leads with the wire nuts.
6. Reattach the new driver and junction box cover
assembly.

Wiring Diagrams

1. For D010TE
BLACK (LINE) BLACK (LINE)
TRAILING EDGE
WHITE WHITE
DIMMING OR
(NEUTRAL) (NEUTRAL)
0-10V DIMMING
DRIVER.
GROUND
4
RED RED
BLACK
LED
PURPLE
BLACK
GRAY
MOUDLE WIRING
DIAGRAM
0-10V DIMMING OPTION
(FIELD INSTALLATION)
Installation Instructions – LDSQ4/LDSQ6 Commercial Recessed LED Rough-In
705077INS
GREEN/BARE COPPER
Figure 11.
Driver
Figure 12.
2. For DL3
BLACK (LINE)
WHITE (COMMON)
GREEN
GROUND
ADP140589 www.eaton.com
BLACK LINE
NEUTRAL
WHITE
GROUND
Junction Box
Cover
RED
BLACK
LUTRON
ORANGE
DRIVER
(120V-277V)
PURPLE
PURPLE
RED
LED
BLACK
MOUDLE WIRING
DIAGRAM
3 WIRE DIMMING
(FIELD INSTALLATION
ONLY)
LUTRON ECOSYSTEM
DIGITAL CONTROL
DIMMING FIELD
INSTALLATION ONLY