Installation - SOPRO COMEG 284 Manual De Utilización

• This medical device is intended for use by a qualified surgeon during endoscopic exploratory
procedures. Its installation does not require any special training. Please refer to the instructions contained
in this manual.
• Place the device on a stable surface and pick up the various accessories that are essential to its
operation.
• If you are using furniture, make sure this is adequately ventilated (at least 15 cm around the device).
• Connect the power cord to the mains socket on the device [C3].
• Set the switch [S3] to position 1, the device is then in standby mode (the green light [L1] should flash
and a logo should appear in the display [L2]).
• Press the Standby button [S1] to switch on the device (the green light is lit and a logo indicating
insertion of a light cable appears in the display [L2]). Pressing the Standby button again will reset the
device to standby.
• Push the light cable into the aperture provided [C1]; you should hear a click as it engages. A logo
indicating that the device is in "iris" mode appears.
• Connect the other end of the light cable to your endoscope.
Before setting up an endoscope (or fibroscope) in front of the camera lens, it is advisable to check the
condition of the endoscope (distal lens or clean eyepiece).
• Press the adjustment knob [S2] or turn it in order to release the light.
The light source is fitted as standard with an adapter for a Storz-type light cable. A version of this
device that is compatible with Olympus-type light cables is also available.
If no light cable is connected to the device when the latter is switched on, a logo
will display this information on the screen. Then you only need to connect up a light
cable in order to see the "iris" logo and use the device.
8
E N G L I S H
5

INSTALLATION

011563 C - 11/2013