Publicidad
Idiomas disponibles
Idiomas disponibles
At "LOAD [□]", press "▲" or "▼" button to select the needed number. The range of
2.10
numbers is from 1 to 9. Then press "ENT" button to load the current method from the
program.
At "T= □□:□□", press "▲"or "▼" button to set operating time.
2.11
The timer range is from 1min to 99hs and 59mins. Then press "ENT" button to save it.
2.12
At "QUIT", press "ENT" button to quit Editing state, and return to Setting State.
2.13
3
Error Alarms
3.1
When the power supply runs with Over-load, it will stop automatically and alarm with
buzzer, then display "ERROR1!". Turn off the switch immediately.
3.2
When the power supply runs with no-load, it will stop automatically and alarm with buzzer,
then display "ERROR 2!". Turn off the switch immediately.
4
Warranty
The Power Supply is warranted for 1 year against defects in materials and workmanship. If any
defects should occur during this warranty period, Nahita will replace the defective parts without
charge. However, the following defects are specifically excluded:
1. Defects caused by improper operation.
2. Repairs or modifications done by anyone other than Nahita Technical Service.
3. Use with cables or connectors not specified by Nahita for this power supply.
4. Deliberate or accidental misuse.
5. Damage caused by disasters.
For inquiries or requests for repair services, contact Nahita Technical Service.
EDIT[ 0 ]
U= 100V
I= 500mA
P= 300W
0
V
0
mA
0
W
15
Publicidad
