Raychem E-100-LR Instrucciones De Instalación página 6

6
E-100-LR Light Replacement Installation Instructions
A
Begin here for light replacement.
WARNING: Shock hazard.
Electrical conductors will be
exposed. Re-entry should only be
performed by qualified personnel.
Turn off power and follow stan-
dard electrical lockout procedures
before opening end seal.
C
• Install new light
into yellow leash.
E
• Use Panduit CT-100
crimp tool and red
insulated butt splices
to crimp new wires to
old wires.
On existing light:
• Cut cable tie (if present).
• Unscrew light.
• Pull excess wire from
inside light.
B
• Cut existing wires approximately
2 in (50 mm) above top of crimps
or core sealer.
• Remove old light
from yellow leash.
2"
(50 mm)
D
• Use 20 AWG wire stripper to remove insulation
from each of the four wire ends.
3/8"
(9 mm)
Leash
3/8"
(9 mm)