Before Setting Oven Controls; Setting Oven Controls - Sears Kenmore 790 Manual Del Usuario

Before Setting Oven
Controls
REMOVING & REPLACING OVEN RACKS
To remove, pull the rack forward until it stops. Lift up front
of rack and slide out. To replace, fit the rack onto the
guides on the oven walls. Tilt the front of the rack upward
and slide the rack back into place.

Setting Oven Controls

Note: The oven function will not work
if the time of day clock is not set.
Note: The oven control has a built-in
safety feature that will shut off the oven
if the control is left on for more than 11
hours 59 minutes.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR
TO OPERATING THE OVEN). Always use oven mitts when using the oven.
Oven Vent Location
The oven vent is located under the left rear surface element. When the
oven is on, warm air is released through the vent. This venting is necessary
for proper air circulation in the oven and good baking results.
ARRANGING OVEN RACKS WITH 5 RACK POSITIONS
To bake on 1 rack, place the rack on position 3 or 4. To
bake on 2 racks, place the racks on positions 2 and 4.
To Set or Change the Temperature for Normal Baking
The oven can be programmed to bake at any temperature from 170°F to
550°F (65°C to 287°C).
To Set the Controls for Normal Baking:
1. Push . "— — —" appears in the display.
2. Within 5 seconds, push the
(177°C)." By holding the
adjusted in 5°F (1°C) increments.
3. As soon as the
the selected temperature. When the displayed temperature reaches the
desired baking temperature, the control will beep 3 times.
4. To cancel the baking function, push
To Change the Oven Temperature after Baking has Started:
1. If you are using the minute timer, push
temperature is displayed.
2. Push the or
9
or . The display will show "350°F
or , the temperature can then be
or is released, the oven will begin heating to
.
and make sure the bake
to increase or decrease the set temperature.