Buick; Century 1982-1996 - Dynex DX-G1113 Guia Del Usuario

Installing your car stereo

Buick

Century 1982-1996

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four screws from the top inside edge of the dash trim bezel.
3 Remove the five screws from both sides of the steering column.
4 Remove the three Phillips screws that secure the rocker-switch housing, then lift the
housing out.
5 Remove the bezel.
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit.
7 Remove and retain the brackets.
8 Go to "Completing the installation" on page 76.
2
S10 shown
as example
9