Sanus VMPL3 Manual De Instrucciones página 6

2 Mount the Wall Plate
Wood stud
2-1 Locate studs
≤ 16 mm
(5/8 in.)
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolts
[11]
[10]
6
Verify the center of the stud(s) using an awl, a thin nail, or an edge
406 mm
to edge stud finder.
(16 in.)
CAUTION:
damage!

Drywall covering the wall must not exceed 16 mm (5/8 in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).

Minimum horizontal space between fasteners: 406 mm (16 in.).
For assistance in determining wall plate location, see Height Finder
at sanus.com. Level the wall plate [01] and mark the hole locations.
CAUTION:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
the lag bolt. To avoid potential injuries or property damage:

DO NOT over-tighten the lag bolts [10].

Tighten the lag bolts [10] only until the washers [11] are pulled
[01]
firmly against the wall plate [01].
Avoid potential personal injuries and property
[01]
Avoid potential injuries or property damage!
Improper use could reduce the holding power of
13 mm 5.5 mm
(7/32 in.)
(1/2 in.)
75 mm
(3 in.)
6901-002348 00