SICO Roll N’ Set Serie Manual Del Proprietário página 4

PIN CONNECTORS
There are (4) four-pin pin connectors, (2) right hand and (2) left
hand two-pin pin connectors on each folding support unit. All
pin connectors have one non-moveable pin (B). The four-pin
connectors have three pins (D) that rotate from the upright use
position to a retracted storage position; the two-pin connectors
have one movable pin each (D). Each pin has an adjustment
screw (F) to secure the deck to the pin connector. Movable
pins (D) and rotatable pin connectors means that the pin
connectors and the two decks that mount directly onto the
folding support do not need to be removed after they are
installed, regardless of where a particular Roll N' Set folding
support is located in the overall stage setup.
• To change a movable pin from the storage position
under the body of the pin connector to the use position,
simply grab the pin (D) and rotate it until it is in the vertical
position; it will automatically lock in position.
• To change a movable pin from the use position to the
• storage position, lift up on the lever (E) on the under-
side of the pin connector and rotate the pin (D) until it is
completely under the body of the pin connector (about
3/4ths of a revolution).
INSTALL THE PIN CONNECTORS
• Install the (4) four-pin connectors
• Install one four-pin connector onto each corner of the
folding support unit. Pull on the spring loaded pin (C) and
set the pin connector over the socket on the corner of the
frame of the folding support. Release the pin (C) and rotate
the pin connector until the pin snaps into one of the four
holes on the socket. Which of the four holes is appropriate
depends upon where this unit will be in the overall stage
setup.
F
B
Universal Pin Connector
(left-hand model shown)
F
D
A
C
E
Page 4