SICO Roll N’ Set Serie Manual Del Proprietário página 6

ADJUST THE HEIGHT
The nominal stage height is etched on the folding support's
inner legs so that you don't have to count holes to get
every unit adjusted to the same height.
At least two people are required to adjust the height. It is
recommended that you change the height no more than
12" [30cm] at one time. If the greater height adjustment is
desired, adjust one side by 12" [30cm], then adjust the oth-
er side to the desired height and then return to the first side
to complete the height adjustment.
1. Ensure the master unit is fully unfolded, with the safety
latch engaged and with the unit sitting on the glides,
not the casters, and that there is nothing on top of the
decks.
2. To lower the master unit from its casters to its glides,
push down on one of the foot levers (B) with the heal of
one foot, then push down on the toe lever (A) with the
toe of that foot, which releases a catch. Allow your leg
to raise as the unit lowers onto the glides. Repeat for
the other side.
3. Disengage the two leg lock pins on one side of the
folding support unit by rotating the yellow handle to
a horizontal position and then pulling outward ninety
degrees. This retracts the leg pin from the inner leg.
CAUTION: Unit may move up or down
when leg pins are disengaged.
4. A lockable gas spring on each side assists with the
height adjustment by supporting much of the master
unit's weight. A black release paddle, which unlocks
the gas spring, must be depressed in order to raise or
lower the unit. The paddle location is identified by a
label and an arrow on the outer frame member at the
side of the folding support.
5. With one person grabbing the frame member, another
person grabs the frame with one hand and pulls the
release paddle with the other hand. Start to raise, or
lower the unit.
A
Toe Lever
B
Foot Lever
Page 6