SICO Roll N’ Set Serie Manual Del Proprietário página 5

• For now, keep the movable pins in the stored position
and orient the pin connector so that the movable pins
are toward the center of the folding support. Later in the
setup, the pin connector may be rotated so that one or
more of the movable pins can be used.
• Install the (2) right hand and (2) left hand two-pin
connectors.
• Install one right hand and one left hand two-pin pin
connector on the sockets near the center of each end of
the folding support frames. The difference between the
right hand and left hand connectors is the orientation of
the spring loaded pin. Install the pin connectors so the
spring loaded pin (C) is facing you when the movable
pin is oriented toward the side. (See image 1)
INSTALL & SECURE THE DECKS
All decks are the same, whether installed directly on a
folding support unit or used as a bridge.
Decks are reversible and, therefore, may have a different
surface on each side. Install the decks with the desired
surface up.
• With at least two people, pick up a deck and set it on
top of the pin connectors mounted on the folding sup-
port.
• Move the deck until all four deck holes drop onto
non-movable pins (B) of the pin connectors on the fold-
ing support unit.
• Using the supplied T-handle hex wrench, secure the
deck by tightening the adjustment screws (F) of all
four pins (B) that engage the deck holes. A rubber
gasket at the base of the pin expands to secure the
deck to the pin connector when the adjustment screw
(F) is tightened. The top surface of the pin should be
approximately flush with the deck surface when the
screw is tight.
• Repeat for the other deck.
Image 1
F
F
B
Page 5